(66) The SIMTECH RMO Series Manual Operated Valve features a compact thermoplastic valve designed to be used with a minimum of hand, foot or knee pressure. This allows one or both hands to be free for other tasks.
This patented valve is designed so there is no metal contact with the fluid.
A Teflon wiper ring prevents most dirt from entering through the top of the valve.
Automatic fail-safe shut-off.
Direct acting full flow and top entry for easy maintenance makes this an ideal valve for most manual applications.
Suitable for most harsh chemicals.
The standard valve is normally closed (push-to-open, release-to-close).
(66) The SIMTECH RLM Series No Lube Manual Operated Valve features a compact thermoplastic valve designed to be used with a minimum of hand, foot or knee pressure. This allows one or both hands to be free for other tasks.
This patented valve is designed so there is no metal contact with the fluid.
A Teflon wiper ring prevents most dirt from entering through the top of the valve.
Automatic fail-safe shut-off.
Direct acting full flow and top entry for easy maintenance makes this an ideal valve for most manual applications.
Suitable for most harsh chemicals. The standard valve is normally closed (push-to-open, release-to-close).
(88) The SIMTECH RFT Series Float Valve is designed to provide maximum efficiency in controlling the liquid level in storage tanks. They can be installed by using a tank adapter directly through the tank wall or with simple piping over the top edge of the tank. The RFT will automatically keep your tank at desired level, preventing overflow by providing positive shutoff. Dynamic seal o-rings are Teflon encapsulated Viton for long life and trouble free operation. The reliability of this valve has been proven in thousands of installations involving acids, caustics, plating solutions, clean and waste water
(36) The SIMTECH RMD Series Modular Wet Bench Dump valve features a compact design that is made to be cemented or welded to the bottom panel of the sink. It is remotely operated with a 3-way (for type 1) or 4-way (for type 2) control valve. It is used to replace trap doors and air cylinders in rinse tanks, etch modules, etc., with no leakage or alignment problems, for less than the cost of a trap door and its required hardware and installation.
Dynamic seal o-rings are Teflon encapsulated Viton for long life and trouble free operation.
It is designed so that the main component can be removed from the installation for easy maintenance and repairs.
(55) The SIMTECH RVB Series Vacuum Breaker features a floating disc that lifts and seals to allow full flow of liquids, DI water, chemicals, etc., and breaks the seal to permit atmospheric pressure to enter when the flow stops to prevent unwanted back siphonage and contamination from getting back into the piping system.
The inlet and outlet ports are parallel and 2 cut-out slots on the base permit easy mounting.
Suitable for most chemicals, wet processing stations, plating equipment, chemical processing and water treatment applications.
(6) The SIMTECH RAP is an adjustable pressure switch with a multitude of uses. This switch may be used to open or close valves, start or stop pumps, sound alarms or limit pressure in tanks. The switch can be wired either normally open or normally closed for either rising pressure or falling pressure.
This patented switch is designed so there is no metal contact with the fluid.
A Viton diaphragm is used to isolate corrosive chemical fluids from the switching mechanism.
It has a ½” FPT conduit inlet and ½” FPT mounting on the bottom center.
All pressure switches are factory pre-set and are adjustable to your needs by rotating the top set screw.
(NOTE: on PVDF pressure switches, ...
(4) Liquid Level Float Switch (RLF)
The SIMTECH RLF Series Liquid Level Float Switch is a compact device ideal for maintaining liquid levels in tanks by activating relays or solenoids which can open or close a valve, sound high or low level alarms, turn heaters and pumps on or off or to light panel mounted indicator lights. It can also be mounted near the bottom of a drum to signal when it is nearly empty. The CPVC stem houses a 1amp 115 VAC reed switch and the polypropylene float is suitable for temperatures to 180 degrees F. 12” extensions with couplings allow this versatile device to be used in most any size tank.
Longer extensions are also available.
A CPVC mounting bracket is available for easy mounting. ...
